Description
Smok T-Air Sub Tank The T-Air Subtank is Smok’s latest edition to their Sub Ohm tank range of tanks with leak free design and top honeycomb airflow for maximum adjustments. A new push fit TA coil system makes changing on the go simpler than ever with: TA 0.15Ω Dual Meshed – 40-60w (Best 55w) FeCrAl Alloy (kanthal)
TA 0.2Ω Single 2-in-1 Mesh – 50-70w (Best 65w) FeCrAl Alloy (kanthal)
TA 0.4Ω Single Meshed – 20-45w (Best 40w) FeCrAl Alloy (kanthal) The tank is easily filled simply 1/4 turn the top cap to remove, refill and twist close. The 7 colour options are: Blue
Gold
Matte Black Plating
Stainless Steel
Gunmetal
Rainbow
Red This tank is available on the Smok Morph 3 kit Specifications: Size: 51.7mm x 26.6mm (Diameter)
Capacity: 2ml
Weight: 66.2g
Thread: 510 Contents: 1 x T-Air Subtank (2ml)
1 x TA 0.15 Ohm Dual Coil (Pre-Installed)
1 x TA 0.2 Ohm Coil
1 x Replacement Glass (2ml)
1 x Manual
Spare Parts How to use the T-Air Sub Tank Notes on changing coils The Smok T-air tank is easy to change coils as they are push fit Unscrew tank from the device
Unscrew the base of the tank
Pull out the old coil
Prime the new coil (see notes on priming coils)
Check the wattage rating on the coil
Push new coil in making sure the littl tabs on the coil line up with the notches on the tank
Screw tank back together
Screw tank onto the device
Fill tank with eliquid (See notes on filling your tank)
Set device to wattage rating on the coil
If coil has been primed you are ready to vape
Enjoy Notes on filling your Tank The Smok T-Air Sub Tank has a simple fill method Unscrew the top cap on top of the tank
Fill in one of the small holes on the side not the middle hole (this can be used for priming see below)
Screw the lid back on Prime the tank. This is done if the coil is new or the tank tastes dry, flavourless or a little burnt tasting Notes on Priming Coils Always prime your coils well when using for the first time especially
Add 7 or so drops to the centre of the coil saturating the cotton inside (either before you install it in the tank or before you fill the tank by adding it via the centre hole between the fill hole on the sides)
Reassemble the tank, if you have changed the coil make sure the coil is secured in place with the little tabs on the coils in the notches on bottom of the tank
Add your chosen liquid to the tank leaving a small air bubble to ensure there is not too much pressure when the top cap is replaced.
Take 5 or so long drags on your device without power (ie do not heat the coils)
To be absolutely sure leave rested upright for a minute or so
